Match each component of WAN connection to its description
|
Cisco (Exam 1)-------CHAPTER 1--------*Quiz 1*A new corporation needs a data network that must meet certain requirements. Thenetwork mustbe fast and reliable to transmit secure video conferencing calls between twobranches. If costis not a consideration, which two types of WAN infrastructure would best meetthe requirements? (Choose two.) Show Get answer to your question and much more Fill in the blank.Branch office networks and corporate headquarter networks can be connectedtogether using ___________VPN connections through the Internet infrastructure. Get answer to your question and much more Which WAN technology uses a fixed payload of 48 bytes and is transported acrossboth switched and permanent virtual circuits? Get answer to your question and much more Which one of the WAN technologies is inadequate for video traffic butoperates adequately for voice traffic? Get answer to your question and much more Match the private WAN technology to its application. (Not all options are used.)- ISDN ----------- when 2 B channels and 1 D- dialup --------- when intermittent- leased line ---- when permanent point-to-point- VSAT ----------- when connectivity in a remoteA construction firm is building a power plant at a remote andisolated mine site and needs to connect the data network of the plantto the corporate network. Which public technology is the most suitable to meetthe 3.With which layers of the OSI model do the PPP control protocols interface? Get answer to your question and much more 4.Which PPP option enables load balancing on PPP-enabled interfaces that connect to a single destination? Get answer to your question and much more 5.Which serial 0/0/0 interface state will be shown if no serial cable is attached to the router, but everything elsehas been correctly configured and turned on? Get answer to your question and much more 6.Refer to the exhibit. A network administrator is configuring the PPP link between the routers R1 and R2.However, the link cannot be established. Based on the partial output of the show running-config command,what is the cause of the problem?
Get answer to your question and much more 7.How many DS0 channels are bounded to produce a 1.544 Mb/s DS1 line? Get answer to your question and much more 8.How much total bandwidth is provided by a T1 line? Get answer to your question and much more Get answer to your question and much more 10.Match the PPP frame field to the description. (Not all options are used.)Flag - a single byte that designates the beginning or end of a PPP frameAddress - a byte filled with all 1sControl - a field with 00000011 so that data link establishment is not requiredProtocol - one (if compression allowed) or two bytesData - 0 to 1500 bytes of informationFrame Check Sequence - up to 4 bytes for error detection A teleworker would like to bundle the Internet connection with other phone and TV services. - Answer: cable A company requires higher download speeds than upload speeds and wants to use existing phone lines. - Answer: DSL A company has a headquarters and four remote locations. The headquarters site will require more bandwidth than the four remote sites. - Answer: Frame Relay A multisite college wants to connect using Ethernet technology between the sites. - Answer: MetroE A company would like guaranteed bandwidth using a point-to-point link that requires minimal expertise to install and maintain. - Answer: T1 What are the 3 WAN connection types?List of WAN connection Types: Automatic IP. Static IP. PPPoE.
What is a WAN connection?A wide area network (also known as WAN), is a large network of information that is not tied to a single location. WANs can facilitate communication, the sharing of information and much more between devices from around the world through a WAN provider.
What are the methods of WAN connections?Some common carrier methods for connecting a WAN network are:. Dedicated Lines.. Frame Relay (discontinued). Ethernet.. SD-WAN.. Dark Fiber.. Which devices is used to connect to a WAN?Routers operate alongside switches in a reciprocal manner to provide access to the WAN. Switches deliver traffic to routers at the network boundary, to access the Internet or transmit information across the WAN.
|
